Krones heater lamp wiring harness

Mon, 06 Jul 2026 06:59:47 +0800

Introduction

When you’re running a KHS PET blow molding line, getting even heat isn’t optional. It’s the whole game. That’s why the Krones heater lamp wiring harness exists. It’s built to work hand-in-hand with your machine’s heating setup, so every PET preform gets the exact same, predictable warmth. This isn’t some off-the-shelf part. It’s a system designed from the ground up to keep the heat stable inside your KHS machine.

The Power Behind the Heat

Let’s get into the guts of it. These heater lamps are spec’d for the real demands of industrial blow molding. They run on 400V, which gives you steady power without drawing too much current. That means less voltage drop across the harness and consistent wattage right where it matters—at the quartz tube. The 300mm length and 2500W output are chosen to cover the preform heating zone perfectly, without spreading heat where it’s not needed. This gives you serious heat density in a tight space, which is exactly what you need for fast cycle times. But here’s the catch: all that heat density means your cooling system has to be up to the task. If the area around the machine gets too hot, performance and lamp life will take a hit.

Wiring on Professional Grade Infrared Heaters

Krones heater lamp wiring harness

Introduction

The Power Behind the Heat